Rafomac News, Tech & Trends That MatterIf your Ecovac Deebot is spinning in circles or struggling to move straight, the right side driving wheel might be the culprit. Replacing it isn’t as daunting as it seems — here’s a detailed walkthrough to get your robot vacuum back on track.
Where to Start Removing the Right Side Wheel
Swapping out the right side driving wheel on your Ecovac Deebot begins by popping off the necessary plugs on the top casing to access the screws underneath. You only need to focus on two screws near the back of the top panel connected to the base—ignore the front screws for now. Once those are out, the quarter panel around the edge can be carefully pried off by lifting its tabs.
Flip the vacuum over next and take out the main rotating brush and its housing to clear your workspace. You’ll see several Phillips screws holding the bottom plate in place; remove those to continue deeper into the assembly.
Freeing the Battery and Bumper for Better Access
With the bottom plate off, the battery is held down by a weighted metal piece that doubles as a balance element. Undo the two screws securing it and gently maneuver the metal piece out of the way—you might have to wiggle it sideways. The battery itself will pop up, allowing you to disconnect its power plug carefully.
Next up, take off the bumper by removing all the screws on the bottom retaining plate around its front edge. Once clear, the bumper is hooked and can be carefully lifted up. There are three plugs underneath—pull these out gently to avoid damaging the wires, then set the bumper aside.
Opening the Body to Reach the Drive Motor
Now, remove the remaining six screws—two inside the battery compartment and four around the outer edge of the base—that hold the body together. After loosening these, you can pry the top cover off with some gentle force around the edges. Be cautious with the wiring connectors when lifting the cover completely free.
Inside, you’ll spot a plate securing the small pump motor beside the right-side wheel; remove the two screws to lift the plate slightly and access the wheel’s rear screw.
Handling the Drive Motor Housing and Wheel Assembly
The drive motor housing is held down by four screws. Before removing those, move the cables and tape overlaying the top to prevent damage. The wheel is spring-loaded and may want to pop up once screws are undone—hold it down carefully until you’re ready. Once free, disconnect the motor plugs and remove the housing.
The housing itself pries apart into two with three clips. Inside, you’ll find the wheel secured by a pin that might need some effort to push out. Note how the wires are arranged to replicate the setup precisely when installing the new wheel. The worn wheel can show damage or cause erratic spinning, so replacing it will solve movement problems.
Fitting the New Wheel and Reassembly
Insert your new driving wheel and push the pin back in, using gentle persuasion if necessary. Before sealing everything up, check that the spring-loaded arm applies the correct pressure to the wheel—this ensures it pops back out properly and maintains ground contact.
Reconnect all plugs carefully, paying attention to correct orientations marked on the connectors. Follow your teardown steps in reverse to put the robot vacuum back together, ensuring cables aren’t pinched or misplaced.
Final Checks and Testing
When reinstalling the bumper, double-check the plugs and that it’s seated correctly to avoid jamming or ‘bumper stuck’ errors. Tighten all screws securely and give your Ecovac Deebot a test run. If it rolls in a straight line, you’ve done it right.
This repair can breathe new life into your robot vacuum without the cost of professional service or replacement. For parts like the driving wheel motor or brushes, affordable options are readily available on sites like AliExpress, matching OEM quality.
If you want to see the full reassembly in action or need guidance on related repairs like the lift wheel or main drive motor, check out the creator’s other detailed videos.
